Arun Sivanand
Support Team
Joined: 20 Apr 2005
Posts: 350
Location: Dubai, UAE
|
 Posted: Mon Jun 25, 2007 3:01 pm Post subject: TOYOTA KEY MATCHING |
 |
|
Dear Aseemalvi,
Please proceed as follows for the Key matching in Toyota vehicles:
GO TO-------Key Code Utility
1. Key Registration
1.1 Master Key
Step 1: The New key will be registered as: MASTER KEY
DO YOU WISH TO REGISTER?
PRESS [YES] OR [NO]
Step 2: NOW REGISTRATION
1. You must REMOVE MASTER KEY within 20s and insert the new key within 10S; otherwise OPERATION TIME will be EXPIRED.
2. Registering will be last for 60s, When the < Security > indicator flash, please wait..., If the < Security > indicator stop flashing, it means registration succeed.
Step 3: Please check< Security > indicator:
1. < Security > indicator stops flashing means registration succeed.
2. < Security > indicator going on flashing means registration failed, you should continue to perform key registration. Press [OK] re-enter system
1.2 Sub Key
Step 1: The New key will be registered as: SUB KEY
DO YOU WISH TO REGISTER?
PRESS [YES] OR [NO]
Step 2: NOW REGISTRATION
1. You must REMOVE MASTER KEY within 20s and insert the new key within 10S; otherwise OPERATION TIME will be EXPIRED.
2. Registering will be last for 60s, When the < Security > indicator flash, please wait..., If the < Security > indicator stop flashing, it means registration succeed.
Step 3: Please check< Security > indicator:
1.< Security > indicator stops flashing means registration succeed.
2. < Security > indicator going on flashing means registration failed, you should continue to perform key registration. Press [OK] re-enter system
2. Key Code Erasure
Step 1: CONFIRM:
1. Registered Master Key is in Ignition switch.
2. Ignition switch turn ON\note: If IG switch turn OFF, EXIT THE MENU, then retry the Key Code Utility. PRESS [YES] or [NO]
Step 2: This function will erase ALL KEY CODES, except the Master key in the cylinder.
Do you wish to continue erasing? Press [YES] or [NO]
Step 3: KEY CODE ERASURE
1. Please take out the master KEY in cylinder within 10s, otherwise Erasing will be failed.
2: if the erasure completed, security indicator should still be blinking.
Step 4: Please insert the Master key and turn IG to ON. If IG is already ON, PLEASE turn IG to OFF, and then turn to ON. PRESS [OK] re-enter system.
3. Auto Reg Closure
Step 1: THIS OPERATIN WILL CLOSE all AUTO REGISTRATION.
DO YOU WISH TO CLOSE?
PRESS [YES] OR [NO]
Step 2: AUTO REGISTRATION MODE WAS CLOSED PRESS [OK]
_________________
Should you need any assitance in Operation and Use of the X431 Please feel free to clarify them with us as per convenience |
|
